Concours Correct tie rod end boot for:
- 1969 Boss 429 (All)
- 1969 Boss 302 (All)
- 1969 Shelby (After April 1st, 1969)
- 1970 Shelby (All)
Concours correct reproduction of the original assembly line tie rod end boot with metal ring. Reproduced from documented original parts and confirmed using original Ford engineering drawings. These boots are almost always split, cracked, dry-rotted, or have been replaced over the last 40-years with an incorrect generic replacement boot.
This is the ONLY correct boot on the market for your original Ford tie rods.
Not suggested for replacement tie rod ends. For use on original Ford tie rod ends only.
- Metal ring internal diameter - 1.375-in - 1.380-in
- Rubber boot hole diameter - 0.585-in - 0.595-in